Skip links

67-72 Ford F100 Rear Mount Tank Bed Fill W Stealth 340 EFI Pump

67-72 Ford F100 Rear Mount Tank Bed Fill W Stealth 340 EFI Pump



1965-1972 F100 Stealth EFI Fuel Tank is perfect for your fuel injected motor requirements. Whether you transplanted a modern fuel injected engine, or added a Holley or FiTech EFI kit, we got you covered.

*Pictures show optional Rollover Safety Vent and Sending Unit installed.
*Lead time Our Coyote swap fuel tanks are made to order, here in the USA and typically ship within two weeks from date of order.

SKU: 14058


-Tank Dimensions: 26.5 x 19 x 10
– Tank Material: .125 Aluminum
– CNC Machined Non Vented / Threaded Cap. on center
– 1/2″ NPT Vent
– 3/8″ NPT Return
-3/8″ NPT Draw
– 3 Baffles
-Approx 19 Gallons
– This tank includes Our Boyd 41001 In-tank pump assembly with an Aeromotive Stealth 340 Pump installed.

*Note* You will need to move the spare tire crossmember forward 3″. See photos for reference.

Our in-tank Aeromotive 340 Stealth Fuel Pump supports up to 700 HP EFI – Forced Induction or 850 HP EFI – Naturally Aspirated. Contact us for other options including our Aeromotive A1000 pump that supports up to 1300 HP EFI.


Flush Bed Fill: Standard bed fill tank with cap. The standard bed fill tank will come with a threaded cap and neck as shown in the pictures which sticks up approx 3”. It is not intended to come through the bed floor, it will be just below the bed floor which will require you to install an access door in the bed floor. You will then open that door reach through and take the cap off the tank to fill it.  If you add the Flush Floor Fill Option you will receive a tank with a 2” Hose barb on the tank and the flush bed floor fill kit which will be mounted into your bed floor then you connect the tank via the supplied rubber hose and clamp.

Fuel Level Sensor: If you are using stock gauges, use the 75-10 OHM resistance option.  If using the Dakota Digital gauges, you can use any OHM resistance. Flange Block Off Kit: If you plan on using the tank before you decide the level sensor you will need a block off kit with gasket to seal the flange for use.

Rollover Safety Vent: The Roll Over Safety Vent is a simple ball check valve that allows air in and out of the tank as needed. In the event of a Roll Over the ball will drop and block the vent port from leaking fuel. Additionally, the ROV also has a small float inside that will help reduce the amount of liquid entering the vent hose from fuel slosh during normal everyday use.

Universal Mounting Kit: Kit Includes: (2) Steel Brackets W/Tapped holes, (2) Weather / Fuel Proof Rubber Isolators, (4) 10-32 x 1 Countersink Screws
(6) 3/8-16 x 1.5″ Bolts, (6) 3/8 Lock Washers, (6) 3/8 Flat Washers, Instructions


Additional information

Rollover Safety Vent

Standard No ROV, Add Rollover Vent

Sending Unit

Standard No Sending Unit, Add 0-90 OHM Sender, Add Block Off Kit, Add 75E 10F Fuel Level Sender (Stock Style Gauges)

Universal Mounting Kit

Standard No Mount Kit, Add Universal Mounting Kit

Bed Floor Fill Kit

Standard Bed Fill Tank with Cap, Add Boyd Universal Flush Mount Bed Floor Kit