Skip links

53-56 F100 Rear NON-EFI Tank– Bed Fill

53-56 F100 Rear NON-EFI Tank– Bed Fill

$449.99

SKU: BW-14067

Description

Tank Dimensions: Fits between frame rails and cross members. No cutting required.
Tank Material: .125 Aluminum
CNC Machined Non Vented / Threaded Cap.
1/2″ NPT Vent
3/8″ NPT Return
#6 ORB Female Pump Outlet
2 Baffles
In-Tank Aeromotive Stealth 340 Pump
Approx 22 Gallons

Note: Our in-tank Aeromotive 340 Stealth Fuel Pump supports up to 700 HP EFI – Forced Induction or 850 HP EFI – Naturally Aspirated.

Flush Bed Fill: Standard bed fill tank with cap. The standard bed fill tank will come with a threaded cap and neck as shown in the pictures which sticks up approx 3”. It is not intended to come through the bed floor, it will be just below the bed floor which will require you to install an access door in the bed floor. You will then open that door reach through and take the cap off the tank to fill it. If you add the Flush Floor Fill Option you will receive a tank with a 2” Hose barb on the tank and the flush bed floor fill kit which will be mounted into your bed floor then you connect the tank via the supplied rubber hose and clamp.

Fuel Level Sensor: If you are using stock gauges, use the 75-10 OHM resistance option. If using the Dakota Digital gauges, you can use any OHM resistance, but we recommend the 240-33 version as it has the most accuracy through the sweep. Flange Block Off Kit: If you plan on using the tank before you decide the level sensor you will need a block off kit with gasket to seal the flange for use.

Rollover Safety Vent: The Roll Over Safety Vent is a simple ball check valve that allows air in and out of the tank as needed. In the event of a Roll Over the ball will drop and block the vent port from leaking fuel. Additionally, the ROV also has a small float inside that will help reduce the amount of liquid entering the vent hose from fuel slosh during normal everyday use.