Skip links

1948-1952 F1 Rear Window Seal Without trim groove

1948-1952 F1 Rear Window Seal Without trim groove

$30.29

This rear window seal goes first on the glass and is installed using the rope-in method. Made from ozone resistant EPDM rubber and from the same OE specs as the original for an authentic fit and finish.

SKU: WBL D2774

Description

Listed Applications

  • 1948 – 1952 Ford – F Series
  • 1948 – 1952 Ford – F1
  • 1948 – 1952 Ford – F2
  • 1948 – 1952 Ford – F3
  • 1948 – 1952 Ford – F4
  • 1948 – 1952 Ford – F5
  • 1948 – 1952 Ford – F6
  • 1948 – 1952 Ford – F7
  • 1948 – 1952 Ford – F8

Installation:
Clean glass thoroughly.
Apply gasket onto glass starting at the corners. Make sure corners and trim are in the right place.
For gaskets without corners, make sure you place the vulcanized seam in the bottom middle of the glass.
Insert a 1/4″ diameter rope in the section at the bottom of the gasket. Starting at the bottom and overlapping 6 to 8 inches.
Spray the gasket with a soapy water solution to help ease installation.
Lay the glass and gasket into the vehicle opening making sure it is aligned squarely.
Start pulling the rope from the inside of the vehicle working slowly across the bottom* and up the sides and finally
across the top*. Gently pat the glass into place with a flat hand from the outside.